why_z-axis_have_offset_when_start_print
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
why_z-axis_have_offset_when_start_print [2015/02/05 09:53] admin |
why_z-axis_have_offset_when_start_print [2019/03/20 04:21] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | The problem is caused by wrong feedrate of Z-axis or wrong resolution Z-axis screw (1600 steps/mm). | ||
| + | |||
| + | To solve this problem, please reset eeprom and try updated Makerware in our website: http://malyansys.com/support/download/ | ||
| + | |||
| + | Or modify Z-axis feedrate for slicer manually. | ||
| + | |||
| + | Makerware users: Please check [[Makerware|this link]] for latest Makerware support. | ||
why_z-axis_have_offset_when_start_print.txt ยท Last modified: 2019/03/20 04:21 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
