This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
why_z-axis_have_offset_when_start_print [2015/02/05 10:02] admin |
why_z-axis_have_offset_when_start_print [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | The problem is caused by wrong feedrate of Z-axis or wrong resolution Z-axis screw (1600 steps/mm). | ||
+ | |||
+ | To solve this problem, please reset eeprom and try updated Makerware in our website: http://malyansys.com/support/download/ | ||
+ | |||
+ | Or modify Z-axis feedrate for slicer manually. | ||
+ | |||
+ | Makerware users: Please check [[Makerware|this link]] for latest Makerware support. |