Malyan System

(**** beginning of start.gcode ****)
(This is start code for The Replicator running a single material print)
M73 P0 (enable build progress)
M103 (disable RPM)
G21 (set units to mm)
G90 (set positioning to absolute)
(**** begin homing ****)
G162 X Y F4000 (home XY axes maximum)
G161 Z F400 (home Z axis minimum)
G92 Z-5 (set Z to -5)
G1 Z0.0 (move Z to "0")
G161 Z F100 (home Z axis minimum)
M132 X Y Z A B (Recall stored home offsets for XYZAB axis)
(**** end homing ****)
G92 X146.5 Y73 Z5
G1 X105 Y-60 Z10 F4000.0 (move to waiting position)
G130 X0 Y0 A0 B0 (Set Stepper motor Vref to lower value while heating)
G130 X127 Y127 A127 B127 (Set Stepper motor Vref to defaults)
M6 T0
M108 T0
G0 X105 Y-60 (Position Nozzle)
G1 Z0.6 F300    (Position Height)
G92 E0 (Set E to 0)
G1 X90.0 E15 F300 (Extrude 4mm of filament)
G92 E0 (Set E to 0 again)
G1 Z0.0 F300    (Position Height)
(**** end of start.gcode ****)