cura_is_printing_using_left_extruder_or_not_extruding
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
cura_is_printing_using_left_extruder_or_not_extruding [2015/11/03 02:34] admin |
cura_is_printing_using_left_extruder_or_not_extruding [2019/03/20 04:21] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | Make sure CURA 15.06 is download from link: [[http://wiki.malyansys.com/doku.php?id=cura_15]] | ||
| + | |||
| + | Follow below procedure to reset settings: http://wiki.malyansys.com/doku.php?id=how_to_clear_eeprom_to_factory_state | ||
| + | |||
| + | Uninstall original CURA and install again. If problem remain, please report to our support email. | ||
| + | |||
cura_is_printing_using_left_extruder_or_not_extruding.txt ยท Last modified: 2019/03/20 04:21 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
