This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
x_y_axis_not_moving [2015/01/06 03:08] admin created |
x_y_axis_not_moving [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | Problem: | ||
+ | X-axis motor not moving but Y-axis good. Or, Y-axis not moving and X-axis OK. | ||
+ | Solution: | ||
+ | |||
+ | Please follow below procedure to check: | ||
+ | - Power off printer, remove power plug | ||
+ | - Open bottom cover | ||
+ | - Swap X and Y axis motor connector | ||
+ | - Power on, enter Monitor menu | ||
+ | - Check if X and Y axis moving using manual function | ||
+ | - If problem motor changed, means stepper driver in motherboard fault. If same motor not moving, means connection of motor have problem. | ||
+ | |