This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tune_pid [2016/07/05 03:31] admin |
tune_pid [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ** Note: Firmware 1.7 and below may cause reset upon M303 command. Update firmware will solve this bug. ** | ||
+ | <code> | ||
+ | M303 S190 | ||
+ | Autotune PID value for extruder at 190C. | ||
+ | |||
+ | M301 | ||
+ | Manually set PID parameters P I and D. | ||
+ | |||
+ | M500 | ||
+ | Save parameters to eeprom. | ||
+ | </code> |