This shows you the differences between two versions of the page.
— |
error_message_from_makerware [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | Windows 10 with Makerware 3.7 is supported. | ||
+ | |||
+ | Please make sure Makerware is cleanly installed, NO PATCH NEEDED. If you are not sure, please reinstall Makerware. | ||
+ | |||
+ | If you encounter below problem, Ex: cannot slice at 0.1mm resolution, report to our support email: | ||
+ | |||
+ | {{:err285a3756.jpg?400|}} | ||
+ | |||
+ | Please attach below information: | ||
+ | |||
+ | 1) OS version | ||
+ | |||
+ | 2) Makerware version and download link (or original setup file name) | ||
+ | |||
+ | 3) Screen copy of error message | ||
+ | |||
+ | 4) Original STL file | ||
+ | |||
+ | 5) Slicing parameters, Ex: 0.1mm/High resolution | ||
+ | |||