dual-extrusion_calibration_pattern_have_no_match_column_row
Differences
This shows you the differences between two versions of the page.
| — |
dual-extrusion_calibration_pattern_have_no_match_column_row [2019/03/20 04:21] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | All M180 is pre-calibrated in factory, users don't have to calibrate dual-extrusion in most cases. | ||
| + | |||
| + | If machine setting is erased(eeprom full reset), calibration value will be reset. | ||
| + | |||
| + | The intergrated dual-extrusion calibration pattern can only adjust +-0.7mm at one time. If needed to adjust left for 2.0mm, please repeat to input value 1 for 3 times. | ||
| + | |||
| + | {{:outofcalv.png|}} | ||
dual-extrusion_calibration_pattern_have_no_match_column_row.txt ยท Last modified: 2019/03/20 04:21 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
