This shows you the differences between two versions of the page.
dual-extrusion_calibration_pattern_have_no_match_column_row [2019/03/20 04:21] |
dual-extrusion_calibration_pattern_have_no_match_column_row [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | All M180 is pre-calibrated in factory, users don't have to calibrate dual-extrusion in most cases. | ||
+ | |||
+ | If machine setting is erased(eeprom full reset), calibration value will be reset. | ||
+ | |||
+ | The intergrated dual-extrusion calibration pattern can only adjust +-0.7mm at one time. If needed to adjust left for 2.0mm, please repeat to input value 1 for 3 times. | ||
+ | |||
+ | {{:outofcalv.png|}} | ||