dual-extrusion_calibration_pattern_have_no_match_column_row
All M180 is pre-calibrated in factory, users don't have to calibrate dual-extrusion in most cases.
If machine setting is erased(eeprom full reset), calibration value will be reset.
The intergrated dual-extrusion calibration pattern can only adjust +-0.7mm at one time. If needed to adjust left for 2.0mm, please repeat to input value 1 for 3 times.
dual-extrusion_calibration_pattern_have_no_match_column_row.txt · Last modified: 2019/03/20 04:21 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
