This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
cura_is_printing_using_left_extruder_or_not_extruding [2015/11/03 02:32] admin created |
cura_is_printing_using_left_extruder_or_not_extruding [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | Make sure CURA 15.06 is download from link: [[http://wiki.malyansys.com/doku.php?id=cura_15]] | ||
+ | |||
+ | Follow below procedure to reset settings: http://wiki.malyansys.com/doku.php?id=how_to_clear_eeprom_to_factory_state | ||
+ | |||
+ | Uninstall original CURA and install again. If problem remain, please report to our support email. | ||
+ | |||