This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
cura_is_not_able_to_save_as_x3g_format [2015/11/03 02:31] admin |
cura_is_not_able_to_save_as_x3g_format [2019/03/20 04:21] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | If SD card is inserted, cura will use "save to card" dialog instead of "save to disk" by default. | ||
+ | |||
+ | **Solution: ** | ||
+ | |||
+ | Load STL file and choose "save to disk" | ||
+ | |||
+ | {{:20151102170609.jpg|}} | ||
+ | |||
+ | {{:20151102170702.jpg|}} | ||
+ | |||
+ | {{:20151030113355.jpg|}} | ||
+ | |||
+ | Select "X3G" extension | ||
+ | |||
+ | {{:20151030113414.jpg|}} | ||