User Tools

Site Tools



This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
changing_parameters [2016/08/08 01:25]
changing_parameters [2019/03/20 04:21] (current)
Line 1: Line 1:
 +Please use USB connection to modify system parameters. ​
 +To obtain config in memory, use command M503:
 +echo:Steps per unit:
 +echo:  M92 X93.00 Y93.00 Z1097.50 E97.00
 +echo:​Maximum feedrates (mm/s):
 +echo:  M203 X150.00 Y150.00 Z1.50 E50.00
 +echo:​Maximum Acceleration (mm/s2):
 +echo:  M201 X800 Y800 Z20 E10000
 +echo:​Accelerations:​ P=printing, R=retract and T=travel
 +echo:  M204 P1500.00 R3000.00 T1500.00
 +echo:​Advanced variables:
 +S=Min feedrate (mm/s),
 +T=Min travel feedrate (mm/s),
 +B=minimum segment time (ms),
 +X=maximum XY jerk (mm/s),
 +Z=maximum Z jerk (mm/s),
 +E=maximum E jerk (mm/s)
 +echo:  M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00
 +echo:Home offset (mm):
 +echo:  M206 X0.00 Y0.00 Z0.00
 +echo:Invert axis: M562 XYZE
 +echo:PID settings:
 +echo:  M301 P20.00 I0.02 D250.00 C100.00 L20
 +echo:  M304 P10.00 I0.02 D305.40
 +echo:​Filament settings: Disabled
 +echo:  M200 D1.75
 +echo:  M200 D0
 +ok N0 P15 B15
 +To change parameters, please type command according to above prompt. Example: ​
 +M92 X100 Y100
 +To save changed parameters, use command M500. 
changing_parameters.txt ยท Last modified: 2019/03/20 04:21 (external edit)