access_denied_when_open_stl_file_in_replicatorg
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
access_denied_when_open_stl_file_in_replicatorg [2015/11/20 08:37] admin |
access_denied_when_open_stl_file_in_replicatorg [2019/03/20 04:21] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | If ReplicatorG is installed in "Program File" directory in newer Windows (later than win vista), may caused access denied warning. | ||
| + | Solution: | ||
| + | |||
| + | 1. Execute ReplicatorG using "Administrator privilege". | ||
| + | |||
| + | or | ||
| + | |||
| + | 2. Copy ReplicatorG into other directory, Ex: "C:\ReplicatorG" | ||
| + | |||
| + | Reference: [[http://replicat.org/installation-windows]] | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
