Table of Contents

M150

Download:

Note: Two firmware available for M150, user can choose Repetier-firmware or Marlin

Firmware updater usage:

  1. Power off printer.
  2. Press center button on panel.
  3. Power up printer, please keep center button pressed.
  4. Release center button.
  5. Look up COM port from windows device manager. Type below command into windows console: avrdude.exe -v -p atmega1284p -c arduino -P com4 -b 57600 -V -U flash:w:marlin.hex
  6. Reboot printer if necessary.

Source Code:

M180

Motion Controller

Firmware updater usage:

  1. Power off printer.
  2. Press center button on panel.
  3. Power up printer, please keep center button pressed.
  4. Release center button.
  5. Look up COM port from windows device manager. Type below command into windows console(Require administrator privilage): update.exe -P COM4
  6. Reboot printer if necessary.

Download:

GUI

GUI update procedure:

  1. Power off printer.
  2. Press center button on panel.
  3. Power up printer, please keep center button pressed.
  4. Release center button.
  5. Push center button again to switch to LCD update mode.
  6. Execute GUI_UPDATE.EXE, select UPDATE_S.bin and correct COM port.
  7. Start update

GUI firmware download link:

Experimental firmware

!!Please note, experimental firmware is only for testing purpose!!

Some users have difficulty with avrdude, please choose m2560 part and stk500v1 programmer in command line.

Reduced cooling fan speed for ABS:

Marlin firmware, accept plain text GCode: