Please use USB connection to modify system parameters.

To obtain config in memory, use command M503:

M503

echo:Steps per unit:
echo:  M92 X93.00 Y93.00 Z1097.50 E97.00
echo:Maximum feedrates (mm/s):
echo:  M203 X150.00 Y150.00 Z1.50 E50.00
echo:Maximum Acceleration (mm/s2):
echo:  M201 X800 Y800 Z20 E10000
echo:Accelerations: P=printing, R=retract and T=travel
echo:  M204 P1500.00 R3000.00 T1500.00
echo:Advanced variables:
S=Min feedrate (mm/s),
T=Min travel feedrate (mm/s),
B=minimum segment time (ms),
X=maximum XY jerk (mm/s),
Z=maximum Z jerk (mm/s),
E=maximum E jerk (mm/s)
echo:  M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00
echo:Home offset (mm):
echo:  M206 X0.00 Y0.00 Z0.00
echo:Invert axis: M562 XYZE
XYZABCD-+-+---
echo:PID settings:
echo:  M301 P20.00 I0.02 D250.00 C100.00 L20
echo:  M304 P10.00 I0.02 D305.40
echo:Filament settings: Disabled
echo:  M200 D1.75
echo:  M200 D0
ok N0 P15 B15

To change parameters, please type command according to above prompt. Example:

M92 X100 Y100

To save changed parameters, use command M500.